|
EC admins, if and when you DO add silicon-controlled rectifiers, the settings you should have for them are below. These are the settings:
TRIGGERING VOLTAGE (gate)
•Min. = 1 milivolt (mV)
•Max. = 1 Megavolt (MV)
•Default = 1 Volt (V)
•Upon being triggered by a pulse of voltage at the gate pin, as long as the voltage at the anode is equal to, or more than, the minimum input voltage, and equal to, or less than, the maximum input voltage, the SCR will conduct voltage, and will keep conducting voltage, until the maximum input voltage is exceeded, or the input voltage is less than the minimum input voltage.
MINIMUM INPUT VOLTAGE (anode)
•Min. = 1 mV
•Max. = 900 V
•Default = 1 V
•SCR cannot conduct voltage, even if the triggering voltage is met at gate, if the voltage at the anode is less than the minimum input voltage.
MAXIMUM INPUT VOLTAGE (anode)
•Min. = 1 V
•Max. = 1 kV
•Default = 9 V
•Component sets on fire if maximum voltage at the anode gets exceeded, even if the SCR has not been triggered by a pulse of voltage applied to the gate pin.
SATURATION CURRENT, OHMIC RESISTANCE, AND JUNCTION CAPACITANCE
•Min. = Same as a normal EC diode
•Max. = Same as a normal EC diode
•Default = Same as a normal EC diode
FORWARD BETA
•Min. = 10 A/A
•Max. = 1 kA/A
•Default = 100 A/A
REVERSE BETA
•Min. = 100 mA/A
•Max. = 30 A/A
•Default = 1 A/A
Thoughts on other SCR settings, or other components you want the EC admins to add to EC and THEIR settings, anyone? If so, please comment down below. Thanks! :-)
-@Redstone_guy
|
