lenzrulz

modified 5 years ago

⭐️Using a N-channel MOSFET transistor as a switch to control a motor⭐️

347

06:05:29

When the SPST switch is open, the 10K pulldown resistor ensures that the N-channel MOSFET transistor is turned off and that the motor is off.

Closing the SPST switch will turn the transistor on and hence the motor on.

The motor is limited to 80.1 rpm but feel free to fine tune the motor settings to whatever rpm range you desire.

Pleas note: This circuit uses an N-Channel enhancement mode silicon  gate power field effect transistor which is specifically designed for use with logic level (5V) driving sources in applications such as programmable controllers, automotive switching and solenoid drivers. This performance is accomplished through a special gate oxide design which provides full rated conduction at gate biases in the 3V to 5V range, thereby facilitating true on-off  power control directly from logic circuit supply voltages.

Enjoy...😎

published 5 years ago

lenzrulz

5 years ago

For low power applications simply place a 50 ohm resistor just beneath the motor and then fine tune the motor to a desirable rpm range such as 164 rpm.

kiani

5 years ago

More nausia

kiani

5 years ago

http://everycircuit.com/circuit/5940810689019904

kiani

5 years ago

And your phsycopathic duplicate account nausia. http://everycircuit.com/circuit/5461729971273728

lenzrulz

5 years ago

More nausea...😡

giomix

5 years ago

Kiani, people like lenzrulz are searching in EC people like you with whom continuosly interact on non electronics argument. Do not you believe this? Try to ignore completely for a period what he writes in everywhere and I believe he will have an hard life.

giomix

5 years ago

And in this manner you will be a different people respect him.

kiani

5 years ago

Here is a demo....http://everycircuit.com/circuit/5461729971273728

lenzrulz

5 years ago

Yes please ignore me and never post your comments on any of my circuits and I will likewise ignore you and never post my comments on any of your circuits....👍

lenzrulz

5 years ago

Umm...just ignore me and don’t post your comments on my circuits...😬

hurz

5 years ago

Read headline, description and watch drawing its clear, Lenny our charlatan is messing here.

gogi3411

5 years ago

NEVER use motor with transistor WITHOUT flyback diode, back EMF in moment of shuting down motor could burn up whole circutry. Back EMF can reach voltages greater than 1000 V. But else circuit is good.

kiani

5 years ago

Plus the circuit is inly good if you use the right Mosfet. Mosfets have a habit of going up in flames, (literally)...

kiani

5 years ago

Yes lenhy is outting this post uo is a metaphorically a dog laying on its bsck and asking its tommy tickeled.

hurz

5 years ago

Yes @gogi3411, you are absolut right! How can an "expert" forget that? Probably hes not an expert and just a charlatan 😀 And there is more to tell the charlatan. About saturation voltage, P vs NMOS, low Vt mosfet, and much more

lenzrulz

5 years ago

Werner missed that point and then embarrassingly jumped onto it, but we can’t expect anything constructive from EC’s most notorious obnoxiously condescending cyberbully...😬

kiani

5 years ago

Thats all lenny wants, his tommy be tickled..

lenzrulz

5 years ago

“his tommy”...😂

kiani

5 years ago

This might help. http://everycircuit.com/circuit/5282567524450304

kiani

5 years ago

Yiu like this http://everycircuit.com/circuit/4980545524858880

lenzrulz

5 years ago

This has previously helped you and you’re welcome: http://everycircuit.com/circuit/6448172919160832

hurz

5 years ago

such a simple circuit, but Lenny you have a talent to make it a crap drawing. @kiani, what do you think about the mosfet properties and its Vds in conducting mode?

kiani

5 years ago

Lenny must have read ctiby s mosfet posts,, so he went in as cow and came out a donkey.

hurz

5 years ago

he drops more then half a volt, LOL. Hes just dialing messy Lenny.

kiani

5 years ago

The collector base junction i in forward bias, disaster.

lenzrulz

5 years ago

How quaint, two foolish peas in a pod...😂

kiani

5 years ago

Is this your way of saying thank you!? lenzul illiterate parrot.!?

lenzrulz

5 years ago

More nausea...😡

lenzrulz

5 years ago

@Bushmills, any atmospheric toxicity comes from your keyboard as evidenced by your REPOSTED LYING NARRATIVES posted BELOW this comment! *BELOW* - Preposition Beneath, under, lower than, less than, inferior to, subordinate to, subject to, controlled by, under the heel of. That’s right, your lying narratives BELOW - never preceding my comments! Unfortunately, not even your cowardly script usage can help you!

add comment in editor