High Side Switching

184

03:35:38

Using a P-Channel Mosfet and a NPN Transistor to switch a 24V non-reactive Load with 5V Signal 

published 7 years ago

hurz

7 years ago

Its an N channel which is in best case a voltage follower and always drops Vgs from drain to source if wired correctly. Use an p channel and the on off logic will change. But keep an eye on max Vgs which is mostlikely less then 24V.

hurz

7 years ago

Check this http://everycircuit.com/circuit/6438526903386112

LucasGrodd

6 years ago

@hurz thanks, i corrected it. I did that back when i started learning electronics

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.