Simple flasher

148

03:18:37

with a simple few parts you can make a flasher

published 8 years ago

BillyT

8 years ago

Nice example, always try to adjust the resistors for 20mA led current, then use a base resistor combo for 20mA / transistor gain, use real world resistor values. Real time on the display is 1 second, (if you display a circuit that you built this is what it would look like.) Always adjust the capacitor to a value that you would like to see if you built the circuit. Remember you cannot see a flash rate much above 20Hz. ; http://everycircuit.com/circuit/5626180089937920

darkphoenix2711

8 years ago

To make the curcate start flashing right away in the simulator i had to slightly offset one of the resistors used to discharge the capacitors, in the real world this should not be a problem.If you want to adjust the flashing rate adjust the two 50k resistors or the capacitors.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.