westelaudio

modified 6 years ago

Components EC should implement

100

00:22:41

Tubes (Triode/Pentode)

Varactor diode

Linear voltage regulator

JFET

Optocoupler

...

published 6 years ago

Bushmills

6 years ago

LDR / photodiode / phototransistor, using actual device sensor.

Bushmills

6 years ago

Mercur switch, using device gravimeter.

Bushmills

6 years ago

Hall sensor, interfacing to actual device sensor

Bushmills

6 years ago

Volume paddles interfacing with potentiometer

Bushmills

6 years ago

digipots

Bushmills

6 years ago

Spam control facility. Ok, not really a component.

Bushmills

6 years ago

Reed contact, also switched by device magnet sensor.

Bushmills

6 years ago

16 byte ROM, table "programmed"

Bushmills

6 years ago

Mux/Demux

westelaudio

6 years ago

@Bushmills good ideas. Thanks for commenting

wyoelk

6 years ago

Folks did you know you can request those and whatever you wish by selecting the + sign at the end of the component list. Claims are that that is sent to the developers

lenzrulz

6 years ago

No one is advertising anything other than their work here on EC. Our wish list must factor in the available real estate on smart devices but additional components are always welcome.

Bushmills

6 years ago

wyoelk, yes, but never ever did anything happen after doing so. No acknowledgement, no change, no putting to discussion, just a lot of nothingness. Push your volume paddle for the same result.

westelaudio

6 years ago

@wyoelk I tried it in the past but nothing happened.

Bushmills

6 years ago

Some may want to see SCRs and triacs

Bushmills

6 years ago

Smaller 7 segment displays with built-in binary-to-7-segment decoder may be nice too.

Bushmills

6 years ago

ECStudio (Android) has JFETs, linear voltage regulators, thyristors, triacs, larger area, for a fraction of the price.

Bushmills

6 years ago

"diodes and transistors models can be inserted through the shared directory". Wires can autoroute, but also laid out manually. About two dozens of connectors, from misc video over coms to gpio, included. Relatively young app (half a year). Spice backend.

westelaudio

6 years ago

@Bushmills that sounds very cool, never heard of that before. When I joined EC, almost exactly 1 year ago, it was pretty much the only curcuit sim app out there.

Bushmills

6 years ago

There were also Droid Tesla and WeSpice

Bushmills

6 years ago

Threre's also Quick Copper - while it can so some simulation, it's currently more considered a schematic editor - but the author intends to upgrade the simulating engine to a full simulator.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.