Full Bridge Rectifier

266

05:47:01

But I don't have any idea why LEDs aren't blinking 

published 5 years ago

PrathikP

5 years ago

The LED's aren't blinking because there is not current flowing through them. Think about why this is the case.

BillyT

5 years ago

A couple of reasons, 1 the earth is in the wrong place. 2 the set time base is a bit fast. 3 unless you have a load the capacitor will charge up an only allow 1 flash. 4 for easy fault finding, draw your circuits in standard formats. SEE. http://everycircuit.com/circuit/6720085505605632

PrathikP

5 years ago

The "earth" is not in the wrong place Billy. The "earth" (actually ground or reference zero) can be anywhere as it is merely a zero volt reference and does not have any behavioural influence on the circuit

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.