This is my best one yet!
Change the wipers to adjust the level of RBG.
Updated from RGB #6: 12/04/23
* Added momentary buttons to add or subtract the intensity of each RGB.
These signals funnel into the final RGB presenting the color.
* Added reset button for Momentary switches.
Note: There are double pole-single output switches on either side of the control - both switches must line up with the method of control to change the color and obtain the proper color. Either method will work to obtain a HEX Code of: #R0G0B0.
Update: 10/13/23
* Flipped potentiometers so that as the parentage increases, the digital output and intensity of the color increases.
* Re-organized order of color and displays to show "Red-Green-Blue" order.
* Made the volt reference 16 V instead of 10 Volts so the dial can go up to "F" at full
intensity.
* Increased clock speed to 1 us.
The Hex is now: #R0G0B0
R = Red display letter or number.
G = Green display letter or number.
B = Blue display letter or number.
This then shows the intensity of each color and resulting RGB Color.
At the bottom of the simulation, you can either allow the clock to update the displays or switch it to manual.
