Stabilized full wave rectifier - series stabilisation

148

03:01:40

Why doesn't this work?? It should just work perfectly fine, but no. I don't understand... :(

published 11 years ago

hurz

11 years ago

1kHz ac source suppose to be 50Hz, and peak voltage must be a little higher to please 12V zener reference or lower zener voltage. 200kOhm against 300uF tau=RC where tau is much to large. Load 5Ohm is very optimistic. Start with 1kOhm.

Uuu

11 years ago

Your wrong at the diodes.

hurz

11 years ago

@Uuu, the diodes are fine. Try again ;-)

kaivanveldhoven

11 years ago

@Hurz Thank you! I hadn't even seen that that resistor was 200 k, qas supposed to be just 200 ohms

hurz

11 years ago

230V is much to high, calculate the wasted power of all components and think about. Anyway, you are welcome!

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.