Hello,
I would like to demonstrate my own crossover for my DIY 100W RMS speakers powered by 50W power amp.
♥♥ Just simply change the frequency input ♥♥
Notes:
- Speakers are replaced by bulps, with same Volt/Watt as signal input (to be representative as a powerspeaker)
- Impedance set by resistors (I would like to see in this app variable impedance according frequency, it would be TOP)
- Crossover frequencies set to 300hz and 4000Hz
- used bypass capacitor for woofer, to keep him blind in high freqs (optional - its hard to find good one on the market, but i still use this solution)
Values of condensators and inductors are rough output from calculation.
