*** GPIO disabled light + temp sensors
Solar version (0 mA), because you can enable the analog sensors by GPIO = HIGH and disabled by GPIO = LOW.
GPIO_D0 --- 1 kOhm --- RESET (DeepSleep)
GPIO_D5 --- on/off Sensor_1 (Light)
GPIO_D6 --- on/off Sensor_2 (Temp)
RST: 1 kOhm (deepSleep/wakeUp)
ADC: 2 kOhm (analogRead)
TEMP: 10 kOhm + 4.7k / 10k + Diode 1111
LIGHT: 100 kOhm + 4.7k / 10 k + Diode 1111
--- ESP8266: ADC max. 1 V !!!
Light + Temp High => 0.870 V / 0.75 mA (max)
At worst case both GPIO set to high.
GPIO_Light = HIGH / GPIO_Temp = LOW
100% = 100 Ohm = 0.599 V / 0.428 mA
99% = 1 kOhm = 0.504 V / 0.396 mA
1% = 99 kOhm = 0.031 V / 0.235 mA
0% = 1 MOhm = 0.003 V / 0.228 mA
GPIO_Light = LOW / GPIO_Temp = HIGH
100% = 10 Ohm = 0.598 V / 0.428 mA
99% = 100 Ohm = 0.588 V / 0.425 mA
10% = 9 kOhm = 0.210 V / 0.296 mA
0% = 100 kOhm = 0.031 V / 0.235 mA
