Diode Ohmic value set to 1 Ohm. Number of windings tbd until I hear from the vendor. Switches added to add/remove smoothing capacitors and ~9 amp resistive load (5 Ohm load simulation) to see their affect on the output signal. The output of this power supply directly feeds 4 gecko G210x stepper motor drivers. This is an attempt to model the power supply I used in my lasers cutter. Www.timsmachines.com (snote: I sell nothing on this site)
***THIS IS A WORK IN PROGRESS...JUST TRYING TO UNDER STAND WHAT I AM SEEING***
Can anyone explain why I don’t see expected 43.3 VDC output, 10 Amp load??
