Peak current mode boost converter

371

03:59:46

PWM signal for switch is generated by comparing sawtooth waveform generated by NE555 with error amplifier signal. Duty cycle is reduced to keep inductor current at maximum level set by current sense resistor. If current comparator detects peak current it turns off transistor switch. This is done by logic shown on schematic. Transistor is enabled again in next clock cycle because CS comparator latch is reset by low signal on PWM generator output. This circuit is also short circuit resistant. 

published 1 year ago

edoseptrizal

1 year ago

hello, nice your job

592azy2circuitdude

1 year ago

You've done a lot of good work with power supplies. I'm enjoying your circuits.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.