For those of you who have been following my flasher circuit designs, thank you and I hope you've enjoyed at least a couple hehe. And i'm sure by now you're familiar with starting the circuit up. For the rest of you lucky viewers, hobbyists and enthusiasts out there we begin by applying V+ via the switch above the supply. Give it a moment and each set of Leds (2 each) will become illuminated- all but the first set which are on either end of the Led bar. That's because at the moment, the first segment transistor is grounded. The next step is to disconnect said transistor from ground by opening the other switch located at the opposite end of the supply. At this point we should be oscillating people! My idea for this design was to have the Led bar moving outward from the center in opposite directions. Fun!..
