Ossiliator

You must be a beginner. That little clock button in the bottom left brings up a menu like what's used to change component values, but it instead changes the simulator speed. If you change both capacitors on the right to 100pF and the inductor to 47nH, and then set the simulator speed to 3nS/S, then it should work. What 3nS/S means is that for every real life second, 3nS (3 nano seconds) will go by in the simulator. This allows you to see, and the simulator to simulate the very high speed oscillations that this circuit produces. If you want it to simulate faster, then you can add a 100MHz sine wave voltage source that's not connected to anything and set the time scale to 30nS/S. That way, it will simulate with the same accuracy but 10 times as fast.

Just change the simulation speed to 300us/s and it will work

EC sometimes needs a kick start, which I prefer rather than shaking the phone http://everycircuit.com/circuit/6122402514993152

Jason9 I did what you said. It didnt work. Maybe ı am just hopeless :D. WTFCircuit I did what you said. Yes it workd for some miliseconds then frequency just disappeared.

What @WTFCircuit said works just fine. Problem with your circuit is the low frequency of 1591Hz this cause the need of a very low 2Ohm resonator impedance. This kind of oscillators are normaly used for much higher frequencies.