Full wave rectifier please help

184

03:23:02

I don't understand what is the problem why this led not going to on.suggest me please.

published 5 years ago

rotmtr

5 years ago

The led arrow need to point to the flow of power which is from source to ground. And your transformer needs adjusting.

rotmtr

5 years ago

For a step down transformer, the primary needs to have more winding numbers than the secondary. For a step up its the opposite.

Chris1960

5 years ago

Reverse the led and put a current limiting resistor in series for a maximum of 20 milliamps

giomix

5 years ago

50 kHz at 233 peak ????? Correct to 50 Hz at 319 Vp, then invert led polarity and insert a resistor in series to led, just to flow 20mA, around 50kohm at 840 volt. In the end increase time speed. But it remains just a little absurd increase voltage from 220 AC rms to over 800 volt DC to enlight a led...

BillyT

5 years ago

The above suppled information is correct, here is a circuit showing the implementation, remember, a tidy circuit is best. http://everycircuit.com/circuit/4846789662081024

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.