Arduino - 6V Relais Modul

295

03:45:03

Arduino Modul - 6V Relais - Zum Ansteuern von Verschiedenen Geräten für den Bereich (CNC/Plasma/Laser/3D-Druck)


12V - Versorgungsspannung 
          (nicht vom Arduino)
5V   - Steuersignal
          (Signal vom Arduino entnehmen)
GND - Masse

Funktion: 
Der Taster Simuliert das Steuersignal vom Arduino, beim Drücken des Tasters wird das Relais geschalten, wodurch ein Seperates gerät ein oder aus geschalten werden kann.

published 5 years ago

wyoelk

5 years ago

Adjust the current limiting resistors for the leds. All leds in this app are 2v and 20ma. So 12v-2v=10v÷20ms=500ohms for current limiting resistor

wyoelk

5 years ago

Try one of these maybe _ _ http://everycircuit.com/circuit/5090821897191424 or http://everycircuit.com/circuit/6372657680089088 or http://everycircuit.com/circuit/6668370968313856

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.