2-to-1 Multiplexer

118

02:26:24

Simple circuit design of 2:1 Multiplexer 
This multiplexer consist of two inputs, if the select line is low then output will switch to D0 input (upper AND gate)
If the select line is high then the output will switch to D1 input (lower AND gate).

published 6 years ago

fatcat2

6 years ago

Maybe you can try this:- http://everycircuit.com/circuit/5880634529284096.

hurz

6 years ago

@fatcat2, maybe you try your own links. Test it after release! The dot at the end is too much

fatcat2

6 years ago

Thanks for spotting out the error! I had been very frustrated as none of my links ever loaded. http://everycircuit.com/circuit/5880634529284096

hurz

6 years ago

@fatcat2, so you think you must place an active LPF after all your logic networks? I cant even see in this network any hazzards or glitches. What is your intention to do this?

fatcat2

6 years ago

Glitches are still present when both the inputs are HIGH. So I added an active LPF.

hurz

6 years ago

and nobody cares for glitches as long the resulting sampling latches are as slow as the ligic itself and even syncronised. BUT , nobody will spend the effort for an ultra expensive active low pass filter. Thats total nonsense

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.