This circuit is made for reset a value of three digits, not directly (ex. 5->0), but step by step (ex. 5->4->3->2->1->0).
You can set the value by pressing the six buttons just above the three displays (only up or down).
The reset cycle will start by pressing the button on the top left corner; the cycle is automatically kept alive until the value shown is "000".
When this value is reached, the circuit deactivates automatically the cycle, so you can set another value.
You can stop the cycle whenever you want by pressing the NC button, placed just below the start one.
You can also set another value while the cycle is activated.
If you like my work, please leave a comment. Thank you!!
I will take in consideration every advice.
- Nat
P.S.: shake your device when you want to stop the simulation ;-)
