This will explain how to wire loud speakers to the amplifier

138

01:05:48

Loud Speaker is 200 Watt 1.5 Volt RMS
Tweeter is 40 Watt 1.5 Volt RMS

Take the Amperes reading and use it as the Wattage reading!

published 10 years ago

hurz

10 years ago

1.5V????

Lucan01

10 years ago

I assumed 1.5v is veing ignored, only focusing on wattages of speakers.

Lucan01

10 years ago

He didn't set this design up correctly, which it probably why it was so confusing at the moment ro understand what he is writing about. The DC source is + and - for speaker wire from speaker box to amplifier. Problem is also he missed to add the crossovers to pair those speakers. He also didn't mention the impedance as well but I assume it don't apply to general design. /end blablablabah~!

Allan1600

4 years ago

LUCAN01 - SINCE WHEN IS A SPEAKER OR LOUDSPEAKER DC POWER? SIGNAL FROM AUDIO SOURCE TO AMPLIFIER IS MAX 150mV 2 Hz to 20 kHz - From the AMPLIFIER TOO THE SPEAKER OR LOUDSPEAKER CAN BE MORE THAN 50+ Vac 1Hz to 20 kHz depending on the LOUDSPEAKER impedance and wattage.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.