TTL

00:58:04

published 12 years ago

Harpreet

12 years ago

Why the output comes as D.C ???

McMAAR

12 years ago

I no expert builder. But play with your source peramiters. Adjust ac /dc voltage and frequencey. After that Im still learning. Good luck

justinmcg67

12 years ago

Adjust AC to 5V. Set Logical True to 5V and the LED as well to 5V. Get a nice square wave from the AC signal. Also you can remove the 1k resistor or adjust to 150-470 ohms works good. IDK what your goal is with this circuit but doing the following I suggested has a nice outcome which is what i think you were going for. In any case i hope this helps. :-)

justinmcg67

12 years ago

Actually just remove the resistor if you have the LED @ 5V.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.