Motorcycle ignition system with lamp for starter motor

198

03:38:46

Simple motorcycle ignition system with a lamp for a starter motor

published 9 years ago

Antonio1961

9 years ago

very good

BillyT

9 years ago

Not bad, but I would remove the earth from the normally closed relay contact, you can get an arc while the relay is starting to move. A diode across the coil will stop its flywheel.

2ctiby

9 years ago

If your lamp represents a starter motor rather than a spark plug, the you would need to adjust the lamp for a lot heavier current.

2ctiby

9 years ago

If your lamp represents a spark plug, then you need a capacitor across your 'points' switch and some means of obtaining a very high voltage for the spark...eg an induction coil.

2ctiby

9 years ago

Your relay as it stands is pointless because it puts the lamp full load through the switch.....a relay is meant to use a low current switch to operate the relay which drives a a heavier load switch....sorry to be a downer on this, but please consider my points and I will help as much as I can.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.