I am rebuilding a module after it burned.
Seems like in the simulation it does not work...
It has 7 components:
- 22 uF capacitor;
- 3.6k ohm and 2k ohm resistors (2 items);
- an UTC8050SL transistor;
- 2 1n4007 diodes;
- and one diode (glass type) wich i believe is a 1n4139.
I didn't try the physical project yet (worry about messing).
It has 1 gnd and 2 Vin, 1 Vin must be brake pedal, the second one from low beams (position).
As output, it has 2 red wires (positive terminals) for brake and position, and 2 grounds (negative), one from transistor base (midle pin) and second is common with the input.
Any advices?
