AND Gate logic blinking led

251

04:24:02

published 11 years ago

mohammed19

11 years ago

anodorotante

11 years ago

Change high voltage to 5v to both, change period to one of them ;)

rbrtkurtz

11 years ago

9v is a little high. Set input voltage to 5v, then set your highs to 5v on the pluses. You don't need two if they're going to both have the same period and duration, though. Also, using 5v, with a 2v LED pulling 20mA, you'll need a 150ohm resistor.

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.