Zener based ripple rectifier. Revised

182

02:47:35

/*
When you push the switch the current(on the LED) goes increasing its intensity till it reach the maximum amount of current, which was projected to be 20mA, both the minimum and maximum.
I'm minding to put its concretization on the electrical network⚠️⚡🔌💡
Thx me!😎
Note:It starts when closing the switch👌
*/

published 6 years ago

BillyT

6 years ago

Not sure of the transformer output voltage, so set it for about 10V. Then got rid of a few unnecessaries: http://everycircuit.com/circuit/5420370828722176

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.