Help

197

04:31:13

Lights should be flashing, whats wrong?

published 11 years ago

Madhunil

11 years ago

No ground bro!..

Madhunil

11 years ago

N discharge pin should be connected to circuit(above resistor)..

Madhunil

11 years ago

Or else it will be in monostalbe state

Madhunil

11 years ago

Monostable#

hurz

11 years ago

Just ground and simspeed to 1s/s else its ok

hurz

11 years ago

@Madhunil, discharge job is taken over by output pin in this special configuration.

Madhunil

11 years ago

Ohh!

supdude

11 years ago

Can someone post repaird verzion

ElectricCow

11 years ago

You need ground to connect it to the circuit, later I don't know what is wrong with your circuit

WTFCircuit

11 years ago

Connect the ground to pin 1, connect a resistor to pin 7 from pin 6, and adjust the simulation speed

Jar1006

11 years ago

te falto http://everycircuit.com/circuit/4641054806507520

cooler007007

11 years ago

You need ground

electricCFE

11 years ago

I missed the ground

henrydeniel

11 years ago

Dont miss the ground its important on circuit

add comment in editor

EveryCircuit is an easy to use, highly interactive circuit simulator and schematic capture tool. Real-time circuit simulation, interactivity, and dynamic visualization make it a must have application for professionals and academia. EveryCircuit user community has collaboratively created the largest searchable library of circuit designs. EveryCircuit app runs online in popular browsers and on mobile phones and tablets, enabling you to capture design ideas and learn electronics on the go.